9

Introduction


Buzzer is a kind of electronic sound receiver with integrated structure. It is widely used as a voice device in electronic products like computers, printers, copying machines, alarm apparatus, electronic toys, auto electronic devices, telephones, etc..In this experiment, we are going to use micro:bit to drive buzzer and make its sound circulate between high frequency and low frequency just like alarm song. And we will present its sound frequency on micro:bit with bar chart format.

Components List:


Hardware:

**Tips: If you want all components above, you will need Elecfreaks micro:bit Starter Kit.**

Major Component Introduction


Buzzer

Buzzer is a kind of voice device. It is made of vibration and resonance device. According to the difference of control method, we can divide buzzer into active type and passive type.

Here’s the working principle of active buzzer: Because active buzzer has integrated amplify sampling circuit and resonance system, when DC power input passes through active buzzer, it will make resonance device generate sound signal. We can see the schematic diagram below for the working principle of active buzzer:

The working principle of passive buzzer is: When square wave signal passes through the buzzer, its resonance device will transform the square wave signal input into sound signal output. Below is the schematic diagram for the working principle of passive buzzer:

Note: In this experiment, we use passive buzzer only.

Transistor

Transistor is a kind of semi-conductor component for current control. It is used to amplify the weak signal to signal with larger frequency.

If we input PWM signal produced by micro:bit into buzzer directly, the buzzer will send out feeble voice. This is because the drive current of I/O port is usually too weak to directly drive components like buzzer. At this time, we have to use transistor to amplify the current of PMW signal so that the buzzer can alarm properly. Here is the circuit diagram for a typical application of using transistor to drive buzzer:

Experimental Procedure


Hardware Connection

Connect your components according to the picture below:

You would see as below after you finish the connection:

Software Programming

Click to open Microsoft Makecode, write the following code in the editor.

Program as the picture shows:

Details for the code:

Reference

Links:https://makecode.microbit.org/_DdPPjDCdmM1a

You can also download the links directly:


Result


The sound sent out by buzzer changes between high frequency and low frequency. And we can see the bar chart of frequency on the micro:bit.

Exploration


If we want to make a high temperature alarming device with a temperature sensor and a buzzer, then how can we design circuit and program?

FAQ